User Manual Q&AAnswer
Feb 17, 2025 - 05:22 AM
To install the Tala BRAS-PAP-01-US Plug-In Pendant, please follow these steps:
1. Decide on the layout for the pendant and ensure you have enough cable for your desired setup. Make sure the dimmer is always accessible.
2. Attach the Node base to the ceiling using appropriate screws and plugs for your ceiling material. Ensure the Node channel runs parallel with the planned cord direction.
3. Position the cord into the Node base at the desired points for your layout. Slide the Insulation Tubes into the center of the Ceiling Nodes. xxxx the Node cap onto the Node base clockwise until secure. Do not over-tighten.
4. Insert the bulb into the pendant by rotating it clockwise until tight. Be careful not to overtighten to avoid breakage.
5. Insert the lamp plug into your chosen wall socket, making sure the power is switched off.
6. Switch the power on and rotate the dial on the dimmer until the bulb lights up. Adjust the dimmer for your desired light output.
Please note that it is important to read the instructions thoroughly before installation and to keep them for future reference. Also, ensure that the power is turned off before inserting the plug to avoid any risk of fire or electric shock.
If you encounter any issues or have further questions, please contact Tala's customer service team at customerservice@tala.co.uk.
Add New Comment