User Manual Q&AAnswer
Feb 17, 2025 - 04:18 AM
To set up the MONNIT MNS2-4-W2-PS Series ALTA Wireless Pressure Sensor, follow these steps:
1. Create an iMonnit account (if you are a new user).
2. Register the sensor and gateway to the same network in iMonnit.
3. Connect and power on the gateway, and wait for it to check into iMonnit.
4. Power on the sensor and verify that it checks into iMonnit. It is recommended to power on the sensor near the gateway and then move it to the installation location, checking signal strength along the way.
5. Configure the sensor for use. This can be done at any point after step 2.
6. Install the sensor in the final location.
For more detailed instructions and information on setting up iMonnit and the gateway, please refer to the iMonnit user guide and the gateway user guide provided with the product.
Note: It is important to perform the steps in the correct order to ensure proper communication between the sensor and iMonnit.
Add New Comment