Answer

Feb 17, 2025 - 03:57 AM
To access the back of your aftermarket radio, you will need to follow these steps:
1. Start by removing the rubber bin insert from the top of the dash.
2. Remove the 7mm bolt under the rubber bin insert.
3. Using a plastic trim removal tool, remove the window switch panel.
4. Disconnect the harness from the window switches.
5. Remove the 7mm bolt behind the window switch panel.
6. Remove the driver knee bolster cover.
7. Remove the (2) 7mm bolts on both sides of the steering column.
8. Remove the center stack/cluster trim.
9. Remove the glove box for access. You will need access to the area behind the glove box to make your connection to the radio.
10. Remove the (4) 7mm bolts to remove the radio from the dash.
Once you have gained access to the back of your aftermarket radio, you can proceed with the installation of the BRANDMOTION SUTV-8849 SummitView Jeep Wrangler Adjustable Rear Vision System.
Add New Comment