Answer

Feb 17, 2025 - 03:08 AM
To install the SPERIAN Fendall 2000 Sterile Portable Eyewash Station with the Heated Accessory, follow these steps:
1. Inspect the Heated Accessory to ensure it is in good shape with no rips or tears in the fabric.
2. Follow steps 1 - 3 in the section "B - Unit Installation" in the manual that came with your Fendall 2000 unit, but use the bracket provided with the Heated Accessory instead.
3. Hang the Heated Accessory from the bracket opening located on the back. Open up the Heated Accessory by unzipping the zipper on the left side of the unit and opening the top and bottom flaps. Replace insulation onto the bracket.
4. Hang the Fendall 2000 unit on the bracket as instructed by steps 4 - 6 in the section "B - Unit Installation" in the manual that came with your Fendall 2000 unit.
5. Follow steps 1 - 9 of the manual, "Fendall 2000™ Cartridge Quick Installation," that came with your cartridge.
6. Close up the Heated Accessory by zipping it up, snapping buttons, and securing the Velcro™ on everything besides the front door.
7. Open the door and pull the headrest towards you.
8. Pull the headrest forward and then pull out the nozzle from the basin. Slide the nozzle into the nozzle compartment, making sure the tube is not twisted and that the small locking hub of the wire tie is facing towards the inside of the unit. Push the headrest back to its original position until an audible 'click' is heard.
9. Place the inner strap of the Heated Accessory's door over the unit door, but hold it towards the top to ensure that the strap will not interfere with the nozzle snapping into the unit's door.
10. Close the unit and Heated Accessory door while holding the inner strap until an audible 'click' is heard. Firmly close the door by making sure the Velcro™ around the door is fully secured. Also, make sure to tuck the top of the Front Door under the Top Flap.
11. Plug the unit into a power source. Push the reset button on the GFCI to re-enable the circuit.
Please refer to the SPERIAN Fendall 2000 Sterile Portable Eyewash Station Instruction Manual for more detailed instructions and illustrations.
Add New Comment