How do I install the HOMEWORKS HRST-8ANS Sunnata RF Switch? (HOMEWORKS HRST-8ANS Sunnata RF Switch User Guide)

Answer

manuals.plus

Feb 17, 2025 - 02:05 AM


To install the HOMEWORKS HRST-8ANS Sunnata RF Switch, please follow these steps:



1. Turn off the power at the circuit breaker before installing to avoid electric shock hazards.



2. Determine the wiring configuration based on whether you are switching lights from one location, two locations, or three or more locations. Refer to the provided wiring diagrams or visit www.lutron.com/wiringwizard for additional assistance.



3. For lights switched from one location, wrap the wires around the  xxxx  and tighten or insert them into the push-in terminals. Use solid copper wire only.



4. For lights switched from two locations, make sure only one switch is used per circuit and that the switch is wired on the load side. Connect the neutral wire to the switch. You can use up to four companion switches.



5. For lights switched from three or more locations, follow the same guidelines as for two locations, ensuring that only one switch is used per circuit and connecting the neutral wire to the switch. Up to four companion switches can be used.



6. Mount all devices using the provided screws and attach the wallplate.



7. Turn on the power at the circuit breaker.



For more detailed instructions and wiring assistance, please refer to the HOMEWORKS HRST-8ANS Sunnata RF Switch User Guide.



Note: It is important to follow all national and local electrical codes during installation.