User Manual Q&AAnswer
Feb 17, 2025 - 01:58 AM
To install the LUTRON Radio RA3 RRST-8ANS Sunnata RF Switch, please follow the steps below:
1. Turn off the power at the circuit breaker before installing the switch to avoid electric shock hazards.
2. Determine the wiring configuration based on whether you are switching lights from one location, two locations, or three or more locations. Refer to the provided wiring diagrams and instructions for each configuration.
3. Ensure that the load type meets the requirements for the switch. The HRST-8ANS switch is designed for use with permanently installed 120V incandescent, magnetic low-voltage, electronic low-voltage, or fluorescent loads, as well as motor loads up to 1/4 HP (5.8A).
4. Make sure a neutral wire is available for all load types.
5. Mount the switch and any companion switches using the provided screws and attach the wallplate.
6. Turn on the power at the circuit breaker.
For more detailed instructions and troubleshooting tips, please refer to the LUTRON Radio RA3 RRST-8ANS Sunnata RF Switch User Guide provided with the product.
Add New Comment