User Manual Q&AAnswer
Feb 17, 2025 - 01:57 AM
To install the REINA RND-SRN5120A Serena Dark Grey Modern Ladder Style Towel Rail, please follow the steps below:
1. Ensure that the radiator is mounted at least 50mm below any overhanging surface (such as a shelf) and no lower than 100mm from the floor. Take measurements and transfer the bracket drill positions to the wall.
2. Drill the wall at the marked positions and insert the wall anchors (included in the package) or other suitable fixings.
3. Place the brackets on the wall and xxxx them to the wall anchors using the provided fixing screws and washers.
4. xxxx the brackets onto the nuts welded on the back of the radiator.
5. Insert the brackets into the wall-mounted brackets and tighten the security screws.
General Recommendations:
- Before fitting the radiator, it is important to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.
- If the system water pH is outside the 5.5-8.5 range or the dissolved is above 0.1mg/litre, it is necessary to protect the heating system components, including the radiator, with a proper chemical treatment compatible with all parts in contact with water.
- Choose the appropriate fixings for the wall material when installing the radiator.
- If the system water exceeds 50°C, it is recommended to install a warning mark near the radiator to avoid accidental scalding.
- Clean the radiator surface only with a soft cloth to avoid scratching the finish. Do not use chemical agents during cleaning operations. It is prohibited to climb on the radiator.
- The maximum working temperature for the radiator is 95°C, and the maximum working pressure is 4 bar.
Please note that this product should be fitted only by a fully qualified installer.
Add New Comment