User Manual Q&AAnswer
Feb 17, 2025 - 01:50 AM
To adjust the low-end trim on the HOMEWORKS HRST-PRO-N Sunnata LED+ RF Dimmer, follow these steps:
1. Press and hold the middle (LED 5) of the light bar until the dimmer goes to the low-end and the low-end setting starts to flash.
2. Slide up or down on the light bar to adjust the low-end trim level.
3. Press and release the Off button to save and exit the low-end trim adjustment.
Please note that if you are setting up the dimmer as part of a system, the phase settings and low-end trim levels made on the dimmer will be overwritten by the system software. For more information on system setup, refer to the Getting Started Guide available at www.lutron.com/HWsupport.
For any further assistance or troubleshooting, please refer to the Troubleshooting section in the instruction manual or contact Lutron support through their website or phone number provided.
Add New Comment