How do I install the MOEN S73104BL One Handle Pre Rinse Spring Pulldown Kitchen Faucet? (Moen S73104BL One Handle Pre Rinse Kitchen Faucet Instruction Manual)

Answer

manuals.plus

Feb 17, 2025 - 01:13 AM


Here are the installation instructions for the MOEN S73104BL One Handle Pre Rinse Spring Pulldown Kitchen Faucet:

1. Place the Deck Gasket onto the base of the Faucet Body, aligning the ribs on the faucet to the slot.
2. Insert the Faucet Body into the sink hole. Note: Install with the handle on the right side only.
3. Slide the Mounting Washer up onto the Faucet Body under the sink and secure it with the Mounting Nut. Tighten the Mounting Nut using the Installation Tool.
4. Thread the Hose Guide onto the end of the shank and tighten it by hand.
5. Attach the Swing Arm onto the Faucet Body securely.
6. Remove the Wand Cap from the Spray Wand.
7. Attach the Spray Wand to the Pulldown Hose and finger tighten.
8. Insert the Pulldown Hose through the Spring.
9. Install the Pulldown Hose and Spring through the Faucet Body.
10. Remove and discard the plastic cap from the end of the Pullout Hose.
11. Install the Pulldown Hose to the Outlet Hose. Push it in as far as possible until a "click" is heard. Tug downward to test engagement.
12. Gently pull down on the Pulldown Hose to ensure the Wand is flush with the Spring.
13. Install the Hose Weight in the bottom of the loop curvature of the Pulldown Hose. Use adjustable pliers to securely clamp the Hose Weight.
14. Attach the Supply Line Hot and Supply Line Cold to the shut-off stops. Tighten with a wrench.
15. Turn the water supply line valves on and check for leaks.
16. Unthread the Wand from the Pulldown Hose and set it aside.

Please refer to the instruction manual for further details and illustrations on the installation process.