User Manual Q&AAnswer
Feb 17, 2025 - 12:02 AM
To install additional fans in the MARSGAMING MC-S1 Gaming Case, follow these steps:
1. Determine the fan size: The case supports two 120mm fans in the front and one 80mm fan in the rear. Make sure you have the correct fan sizes before proceeding.
2. Prepare the case: Remove the side panel of the case by unscrewing the screws at the back. This will give you access to the internal components.
3. Front fan installation: To install the front fans, locate the fan mounting points on the front panel. These are usually located behind the front panel mesh. Use the included screws to secure the fans in place. Connect the fan cables to the appropriate fan headers on your motherboard.
4. Rear fan installation: To install the rear fan, locate the fan mounting point at the back of the case. Use the included screws to secure the fan in place. Connect the fan cable to the appropriate fan header on your motherboard.
5. Cable management: Once the fans are installed, make sure to route the fan cables neatly to avoid any obstructions or tangling. Use cable ties or Velcro straps to secure the cables in place.
6. Test the fans: After installing the fans, close the side panel of the case and power on your system. Check if the fans are spinning and functioning properly. You may need to adjust the fan speeds in your motherboard's BIOS or software.
Please refer to the MARSGAMING MC-S1 Gaming Case Owner's Manual for more detailed instructions and illustrations on fan installation.
Add New Comment