User Manual Q&AAnswer
Feb 16, 2025 - 11:45 PM
To install the NICOR NLCPC1 Network Lighting Controls, please follow these steps:
1. Make sure the luminaire can be controlled by a 0-10V dimmer.
2. Carefully unpack the unit from its packaging and inspect it for any shipping defects.
3. Turn off power to the appropriate circuit at the breaker panel.
4. Route the wires and device threading through a ½” knockout.
5. Place the lock-nut over the wires and xxxx it onto the threading to tighten the controller.
6. Connect the controller wires using the wiring diagrams provided in the manual, according to their designated uses.
7. Turn the power ON and follow the Nicor NLC commissioning guide for further instructions.
Please note that it is recommended to have a licensed electrician perform the installation to ensure safety and compliance with electrical codes. Always disconnect power before installing or servicing the product, and wait until the fixture has cooled down before working on it.
For more detailed information and illustrations, please refer to the NICOR NLCPC1 Network Lighting Controls Instruction Manual.
Add New Comment