How do I install and calibrate the FLYSKY FRM303 RF Module? (FLYSKY FRM303 RF Module User Manual)

Answer

manuals.plus

Feb 16, 2025 - 11:23 PM


To install and calibrate the FLYSKY FRM303 RF Module, please follow the instructions below:

1. Ensure that the product is installed correctly: Make sure the RF module is securely connected to your compatible device. Refer to the device's user manual for specific installation instructions.

2. Calibrate the RF module: Calibration is essential to ensure accurate and reliable performance. Follow these steps to calibrate the RF module:

   a. Power on your compatible device and the RF module.
   b. Keep the RF's antenna at least 1cm away from conductive materials such as carbon or metal.
   c. Do not hold the RF antenna during use to ensure good signal quality.
   d. Do not power on the receiver during the setup process to prevent loss of control.
   e. Make sure to remain within range to prevent loss of control.

3. Use an external power supply (recommended): It is recommended to use an external power supply to ensure that the RF module receives enough power to function correctly. The FRM303 supports three modes of power supply: 5 ~ 28V/DC for XT30 interface, DC 5 ~ 10V for the signal interface, and 4.5 ~ 5.5V/DC for the Type-C USB port.

Please refer to the FLYSKY FRM303 RF Module User Manual for more detailed instructions and information on binding, model selection, RX interface protocol setting, failsafe, and other features and specifications.