How do I install the Puig REF 20770N Kickstand Extension? (Puig REF 20770N Kickstand Extension Instruction Guide)

Answer

manuals.plus

Feb 16, 2025 - 11:19 PM


To install the Puig REF 20770N Kickstand Extension, please follow the steps below:

1. Ensure that you have all the required parts mentioned in the manual: 
   - Aluminum base (1 piece)
   - Upper plate (1 piece)
   - M5x8 DIN1001 INOX screws (4 pieces)

2. Consult the manufacturer's website for the availability of the installation video for this specific reference. The video will provide visual guidance on the installation process.

3. If the video is not available, you can proceed with the following steps:

   a. Start by placing the aluminum base on the ground, aligning it with the kickstand of your motorcycle.

   b. Insert the kickstand into the slot on the aluminum base.

   c. Take the upper plate and position it on top of the kickstand, aligning the holes with the holes on the aluminum base.

   d. Insert the M5x8 DIN1001 INOX screws through the holes on the upper plate and tighten them into the corresponding holes on the aluminum base. Use all four screws to ensure a secure installation.

   e. Double-check that all screws are tightened properly, but be careful not to overtighten them.

4. Once the kickstand extension is securely installed, test it by deploying and retracting the kickstand to ensure smooth operation.

Please note that these instructions are a general guideline, and it is always recommended to refer to the specific installation manual provided by the manufacturer for detailed and accurate instructions.