How do I install the EnOcean EASYFIT EOSD Occupancy Sensor Sub Desk? (EnOcean EASYFIT EOSD Occupancy Sensor Installation Guide)

Answer

manuals.plus

Feb 16, 2025 - 10:58 PM

To install the EnOcean EASYFIT EOSD Occupancy Sensor Sub Desk, follow these steps:

1. Remove the sensor from the packaging.
2. Remove the mounting plate from the sensor.
3. Insert the CR2032 battery under the clip with the positive pole (+) up and press it in place.
4. Decide where you want to install the occupancy sensor, keeping in mind the recommended mounting height of 2.45-3.15 feet (70-90cm) and the need for a minimum clearance of 4 ft. (1.2 m) from any heat sources.
5. Choose the appropriate installation option - gluing or screwing.
6. If using the adhesive tape, fix the mounting plate to the sub-desk surface.
7. Attach the sensor to the mounting plate by sliding it until it snaps into place.
8. Confirm that the sensor is properly positioned to detect motion by conducting a walk test.

Please refer to the "Installing" section of the EnOcean EASYFIT EOSD Occupancy Sensor Sub Desk Installation Guide for more detailed instructions and illustrations.

Note: It may be easier to link the sensor before mounting it sub-desk. Please refer to the "Linking" section of the installation guide for instructions on how to link or unlink the occupancy sensor with other devices in the system.

Remember to follow the safety instructions provided in the manual, such as not exposing the product to rapid temperature changes, avoiding moisture condensation, and disposing of used components properly.

If you encounter any issues during installation or have further questions, please consult the troubleshooting section of the manual or contact EnOcean customer support for assistance.