User Manual Q&AAnswer
Feb 16, 2025 - 10:53 PM
To install the Soap Injector Kit on the BCS Pressure Washer, you will need to switch the hose and pump fittings and then install the kit between the pump and the hose. Here are the installation instructions:
1. The BCS Pressure Washer comes with a hose that has one male and one female connector on each end. The pump of the pressure washer has a male connector.
2. To install the Soap Injector Kit with the correct water flow direction, you need to exchange the female connector from the hose with the male connector from the pump.
3. Once the connectors are exchanged, the Soap Injector Kit can be installed between the pump and the hose.
4. Refer to figure 1 in the user manual for a visual representation of the pump and hose connectors.
5. For further assistance or if you have any questions, you can contact BCS America at 1-800-543-1040 or email info@bcsamerica.com.
Please note that the user manual for the BCS 85.400.001 Soap Injector Kit for Pressure Washer provides additional details and illustrations that may be helpful during the installation process.
Add New Comment