User Manual Q&AAnswer
Feb 16, 2025 - 10:18 PM
, follow these steps:
1. Connect the power supply wires to VDD and GND on the receiver.
2. When the power is initiated, the LED on the receiver will light for 1 second, indicating that it is ready for learning.
3. To add a new code into Channel 1, press the LEARN BUTTON once. The LED will light for 1 second, go off for 1 second, and then light again.
4. Press any button on the transmitter. If the code is learned successfully, the LED on the receiver will blink. Release the button on the remote, and the LED will turn off. If the remote cannot read the signal, the LED will light for 10 seconds and finish its learning status.
5. To add a new code into Channel 2 (if applicable), press the LEARN BUTTON twice. Follow the same steps as above.
6. Repeat these steps for any additional transmitters you want to pair with the receiver.
Please refer to the W BOX 0E-1CHRFRCVR and 0E-2CHRFRCVR One and Two Channel RF Receiver Installation & Operation Guide for more detailed instructions and illustrations.
Add New Comment