User Manual Q&AAnswer
Feb 16, 2025 - 09:54 PM
To set the combination for the LOCKER DOWN LD2023 Console Safe for Ford Explorer, follow these steps:
1. Clear out the contents of the center console before starting the installation process.
2. Before installing the safe, it is recommended to set the combination with the door open to test the lock combination effectively without locking yourself out.
3. Place the BOTTOM PLATE at the bottom of the console compartment, ensuring that the half moon is facing the rear.
4. Place each SIDE PLATE in the console compartment on top of the bottom plate, making sure that the shorter end is facing towards the front and the lip is facing inward.
5. Place the TOP ASSEMBLY in the console compartment so that it sits on the tops of the lips of the side brackets and the front is under the lip of the console. To do this, set the top assembly in initially at a forward angle.
6. Use an 8mm socket bit to attach the top assembly to the side plates using the provided acorn nuts.
7. Tighten the side bolts on the safe using a T30 torques bit. Be careful not to over-tighten, as this could damage the console or the safe.
8. Re-insert the padding that was removed from the safe before installation.
9. With the safe properly installed, you can now set the combination. Please refer to the specific instructions provided with the combination lock mechanism that came with your safe.
10. Enjoy your purchase and the added security provided by the LOCKER DOWN LD2023 Console Safe for Ford Explorer.
Please note that the specific instructions for setting the combination may vary depending on the type of combination lock mechanism included with your safe. It is important to refer to the instructions provided with the lock for accurate and detailed guidance.
Add New Comment