User Manual Q&AAnswer
Feb 16, 2025 - 08:41 PM
To set up and use the aCPAP device for the Run-In Night in Sleep SMART, follow these steps:
1. Setting Up the aCPAP Unit:
- Place the device on a stable level surface.
- Plug the power connector into the rear of the device and connect the power cord to the power outlet.
- Connect the air tubing firmly to the air outlet located on the rear of the device.
- Open the water tub and fill it with distilled water up to the maximum water level mark. Do not use hot water.
- Close the water tub and insert it into the side of the device.
- Connect the free end of the air tubing firmly onto the assembled mask.
2. Getting Started:
- Make sure the power is connected.
- Adjust the humidification level if required.
- Adjust the mask as described in the mask user guide.
- To start therapy, press the Start/Stop button or simply have the subject breathe into the mask. The device will turn on.
- Have the subject lie down and arrange the air tubing so that it is free to move if they turn during sleep.
- To stop treatment, press the Start/Stop button and remove the mask.
3. Using PAP at Bedtime:
- Always fill the water tub with distilled water only.
- Put on the mask and start the device. The device will increase flow if it senses a leak.
- Place the tubing above the headboard or between the pillow and the wall to keep it out of the way during sleep.
4. The SmartStart Feature:
- The aCPAP device has a comfort feature called SmartStart/SmartStop that starts the device automatically when the subject breathes into the mask and stops it when the subject removes the mask.
- If the subject does not like this feature, it can be disabled by contacting the Sleep SMART Care Team.
5. Restarting PAP during the Sleep Cycle:
- If it is necessary to interrupt use of PAP, stop the device and either disconnect the tubing at the mask or take the mask off.
- When returning to bed, reassemble the connection or reapply the mask and push Start/Stop again or simply breathe into the mask. The device will restart using the same lower pressure it started with.
6. When They Wake Up:
- Turn off the aCPAP unit by pushing the Start/Stop button or removing the mask.
- Disconnect the hose and remove the water from the water tub.
- Clean the hose and water tub if the subject is randomized to the aCPAP intervention arm of Sleep SMART.
Please refer to the FusionHealth aCPAP Components Sleep Smart Care User Manual for more detailed instructions and information on using the aCPAP device during the Run-In Night in Sleep SMART.
Add New Comment