How do I install the LITETRONICS HBC Series LED High Bay PL fixture? (LITETRONICS HBC Series LED High Bay PL Instruction Manual)

Answer

manuals.plus

Feb 16, 2025 - 08:20 PM

To install the LITETRONICS HBC Series LED High Bay PL fixture, follow these steps:

1. Turn off power at the circuit breaker before starting the installation.
2. The fixture can be mechanically supported using a hook, chain, or cable (not included). Secure the fixture to the snap hook (included) on top of the fixture. For pendant mounting, leave the snap hook off and xxxx the conduit directly into the fixture.
3. Once the fixture is supported, attach the included safety cable to a beam or structural support.
4. If you want to enable dimming without a sensor, make connections between the dimming wires (purple (+) and gray (-)) and the dimmer using the included waterproof wire nuts. Depending on the voltage, connect the input wire to the AC branch circuits as shown in figures 1-3. Ensure compliance with national and local codes. If 0-10V dimming is not needed, you can cap off the purple (+) and gray (-) wires.
5. If you are using the plug-in sensor (part # SC005, sold separately), any dimming will be controlled through the sensor. The dimming wires do not need to be connected and can be capped off. Connect the input wire to the AC branch circuits as shown in figures 1-3, following national and local codes.
6. After completing the wiring, restore power at the circuit breaker. If applicable, switch on the dimmer.
7. If you are using the sensor model, you can customize various settings using the remote control (part # SCR053, sold separately). Instructions for sensor settings are included with each remote control.

Please refer to the installation instructions provided in the box for more detailed information and diagrams. If you have any specific questions or need further assistance, you can contact LITETRONICS customer service at 1-800-860-3392 or via email at customerservice@litetronics.com.