User Manual Q&AAnswer
Feb 15, 2025 - 03:47 AM
To test the eldes EWC1W Wireless Double Technology Outdoor Detector, follow these steps:
1. Open the lid of the detector.
2. Set the Dip4 switch to the ON position.
3. Close the lid.
4. The LEDs on the detector will now be active, and the sensor will not inhibit any detections.
5. Adjust the flow rate of the infrared and/or microwave as needed.
6. Conduct the desired tests.
7. To end the test mode, open the lid again, set the Dip4 switch to the OFF position, and close the lid.
8. The sensor will enter low-power mode after 3 minutes.
Please note that after each detection, the sensor will remain inactive for at least 3-6 minutes, as determined by the Dip2 switch.
For more detailed instructions and information, refer to the eldes EWC1W Wireless Double Technology Outdoor Detector User Manual.
Add New Comment