Answer

Feb 15, 2025 - 01:41 AM
To properly install the COREMORROW P33 Piezo Tip-Tilt Platform, please follow these steps:
1. Before attaching the mirror, clean both the mirror and the motion surface. Allow the adhesive to solidify before proceeding.
2. Use M3 screws to mount the P33 on the mounting surface. Alternatively, you can use an adapter provided by COREMORROW. Ensure that the mounting surface and adapter are clean before mounting.
3. Connect the grounding protection for the connection. Refer to Figure 7 in the manual for the correct grounding setup.
4. When mounting the load, ensure that the load quality is within the maximum load capacity of the P33. Mount the load in the center of the moving surface for optimal balance.
5. Tighten the load slowly to avoid applying excessive torque, which could damage the mechanism.
6. Use the dedicated cable provided by COREMORROW to connect the P33 Piezo Tip-Tilt Platform to the controller. Do not connect via an extension cable unless specifically recommended by COREMORROW.
7. Before turning on the power, ensure that the operating environment meets the requirements specified in the manual. Also, make sure that all fixed screws are tightened.
8. Read the user manual of the controller carefully before operation. Set the controller's output voltage to zero before proceeding. Then, input the desired voltage value within the specified input voltage range.
9. During operation, take light steps and avoid knocking or damaging the product.
It is important to note that these are general installation guidelines. For more specific instructions or if you encounter any difficulties during installation, please refer to the COREMORROW P33 Piezo Tip-Tilt Platform User Manual or contact COREMORROW customer service for further assistance.
Add New Comment