How do I assemble the BLACK WIDOW BW-PRO-CHOCK Motorcycle Wheel Chock? (BLACK WIDOW BW-PRO-CHOCK Bike Wheel Chock Instruction Guide)

Answer

manuals.plus

Feb 15, 2025 - 01:24 AM


To assemble the BLACK WIDOW BW-PRO-CHOCK Motorcycle Wheel Chock, please follow these steps:

Step 1: Slide the two legs (C) into the slots on the base (A). Each leg should fit into its own slot, facing opposite directions so they can extend or contract as needed. Fit the turn knobs (H) into the top holes to secure the legs at the proper distance. The distance can be adjusted to fit a truck bed or trailer once the chock is assembled.

Step 2: Fit the vertical arm (B) into the base (A). Secure it with a pin and clip (I).

Step 3: Fit the arm bracket (F) onto the vertical arm (B). Secure the bracket at the appropriate height with a pin and clip (I).

Step 4: Attach the wheel stop (E) to the arm bracket (F) using a pin and clip (I).

Step 5: Attach the cradle bracket (G) to the base (A) using the bolts (J), washers (K), and nuts (L). Secure it with a 5mm hex key and 13mm wrench.

Step 6: Attach the wheel cradle (D) to the cradle bracket (G). Secure the cradle at the appropriate position with a pin and clip (I).

Please refer to the provided manual for visual illustrations and additional details.

Note: If you want to use two chocks together, you can remove one leg from the inside of one chock and remove the end cap of the inside leg of the other chock. Make sure the slot for the removed leg and the other inside leg line up. Fit the leg into the slots of both chocks, connecting them. Adjust and tighten as needed.

Remember to always inspect the product before use to ensure it is assembled properly and all parts are in safe working order and free of defects.