How do I install the LUTRON Roller 64 WIDR Standard Mount? (Lutron Roller 64 WIDR Mount Installation Guide)

Answer

manuals.plus

Feb 15, 2025 - 12:46 AM


To install the LUTRON Roller 64 WIDR Standard Mount, follow these steps:

1. Mark the Mounting Bracket Locations: Use a level to mark the location of the mounting brackets over the window. Ensure that the screws will be driven into a structural member capable of supporting the operating load of the shade system.

2. Install the Mounting Brackets: Using appropriate fasteners for the mounting surface, install the mounting brackets at the marked locations. Make sure to install 4 screws per bracket when mounting to a wall or ceiling.

3. Cable Entry: The cable should exit from the wall, ceiling, or jamb on the drive side of the system. Leave 12-18 inches of cable exposed. Ensure that the cable entry location and bracket location do not conflict.

4. Orient the Buttons and Drive Cables: At the drive end of the shade, choose the orientation in which the control buttons will be more easily accessible after installation. The square mounting yoke on the shade fits over the tabs on the mounting bracket, and has notches on each side. Orient the yoke and route the drive wire(s) through the appropriate notches based on the bracket orientation.

5. Mount the Shade: This procedure requires two people. Align the idler mounting yoke with the shade bracket mounting tabs and fit the yoke around the tabs and behind the head of the retaining  xxxx . Depress the spring-loaded idler and fit the drive-end mounting yoke over the tabs and behind the head of the retaining  xxxx  on the drive end shade bracket.

6. Check and Secure the Shade: Measure and verify that the idler-end light gap is 3/4 inch, ± 1/8 inch. Ensure that the installed shade system is level and centered on the window opening. Tighten the retaining screws at each end of the shade to secure it, but do not overtighten.

7. Wiring and Power-Up: Follow the instructions in the enclosed document "Sivoia QS Basic Wiring and Setup" to complete the shade wiring and set limits. Run the shade up and down several times to verify smooth movement and make any necessary adjustments.

For more detailed information and safety precautions, refer to the LUTRON Roller 64 WIDR Standard Mount Installation Guide provided with the product.