User Manual Q&AAnswer
Feb 14, 2025 - 11:48 PM
To connect the Janitza RCM 202-AB Residual Current Measurement Device to the power supply, follow these steps:
1. Make sure the power supply is disconnected before starting any work.
2. Connect the plug for the power supply to the N/L connection on the RCM 202-AB.
3. The status LED on the device will start flashing green, indicating that the device is initializing.
4. Wait for the initialization process to complete. This can take up to 60 seconds.
5. Once the initialization is complete, the status LED will light up green and the measured values for the activated measurement channels will be shown on the display.
6. The RCM 202-AB is now ready for operation.
Please note that these instructions are a general overview. For more detailed information and safety instructions, please refer to the Janitza RCM 202-AB Residual Current Measurement Device Instruction Manual.
Add New Comment