Answer

Feb 14, 2025 - 10:36 PM
To install the BriskHeat TTH Series HotPoly Silicone Tote Tank IBC Heater, follow these steps:
1. Remove the polyurethane bottle from the cage or pallet and remove any cardboard and/or paper insulation.
2. Place the heater in the bottom of the cage with the black (insulation) side down and the orange (heater) side up. Make sure the heater is as far back from the front (nozzle side) as possible, and the power cord exits the front of the cage or IBC.
3. Place the bottle into the cage on top of the heater, making sure the plug and power cord are outside the cage and not under the heater.
4. Fill the bottle with the product.
5. Connect the heater power cord to the TTD controller receptacle, and the sensor plug to the TTD controller sensor jack. BriskHeat recommends using TTD series controllers with this product (sold separately). The TTD digital On/Off thermocouple temperature controller is designed for outdoor use.
Please note that all electrical connections must be made by qualified personnel and in accordance with all applicable codes and regulations.
For further information or troubleshooting, refer to the BriskHeat TTH Series HotPoly Silicone Tote Tank IBC Heaters Instruction Manual or contact your local distributor/representative or BriskHeat directly at 1-800-848-7673 or 614-294-3376.
Add New Comment