User Manual Q&AAnswer
Feb 14, 2025 - 09:37 PM
To light the pilot on the Parry 7072P Salamander Wall Grill, follow these steps:
1. Make sure the gas supply is turned on to the appliance.
2. Push in and turn the xxxx to the spark position to ignite the pilot. If there is no spark, contact the distributor for an engineer.
3. Hold the xxxx in the spark position for 15-20 seconds, then release. The pilot should stay lit.
To light the burner on the grill, follow these steps:
1. After the pilot is lit, turn the xxxx to the large flame symbol. This will ignite the main burner.
2. The smaller flame symbol represents a lower rate setting.
3. To turn off the burner, turn the xxxx in a clockwise direction until you feel a slight stop. Press in slightly to turn the xxxx to the off position.
Both pairs of burners, left and right, can be lit using the same method. Once lit, they can be used on full heat, low heat, or any combination.
Please note that this appliance should not be left unattended when switched on, and it should only be used by qualified individuals.
Add New Comment