User Manual Q&AAnswer
Feb 14, 2025 - 09:33 PM
To install the NOTIFIER NRX-M711 Radio System Input-Output Module, follow these steps:
1. Remove the 2 screws from the front cover to reveal the RF module.
2. Remove the RF module from the back box.
3. xxxx the back box to the desired position on the wall using the fixings provided.
4. Refit the module in the box.
5. Wire the plug-in terminals as required by the system design.
6. Refit the front cover to protect the module.
Note: When installing the module, make sure to follow all relevant codes and regulations. The spacing between radio system devices should be a minimum of 1m.
For more detailed installation instructions, refer to the "Module installation instructions" and "SMB500 back box installation instructions" provided in the package.
Please refer to the NOTIFIER NRX-M711 Radio System Input-Output Module Instruction Manual for further information and illustrations.
Add New Comment