User Manual Q&AAnswer
Feb 14, 2025 - 09:04 PM
To install the anti-tip bracket for the AMANA W11508819B 30-Inch Freestanding Gas Range, follow these steps:
1. Remove the anti-tip bracket from where it is attached inside the oven with a wire tie.
2. Determine whether you will be using the floor or wall mounting method. If you have a stone or masonry floor, you can use the wall-mounting method. If you are installing the range in a mobile home, you must secure the range to the floor.
3. Determine and mark the centerline of the cutout space. Position the mounting bracket against the wall in the cutout so that the V-notch of the bracket is 9 5/8 inches from the centerline.
4. Drill two 1/8-inch holes that correspond to the bracket holes of the determined mounting method.
5. Using a Phillips screwdriver, mount the anti-tip bracket to the wall or floor with the two #12 x 1 5/8-inch screws provided.
6. Move the range close enough to the opening to allow for final gas and electrical connections. Remove any shipping base, cardboard, or hardboard from under the range.
7. Move the range into its final location, making sure the rear leveling leg slides into the anti-tip bracket.
8. Move the range forward onto the shipping base, cardboard, or hardboard to continue installing the range.
Please refer to the installation guide provided with the product for more detailed instructions and illustrations. It is important to properly install the anti-tip bracket to ensure the safety of the range and prevent tipping hazards.
Add New Comment