How do I install the Westinghouse 61242 Lighting Queensland One-Light Outdoor Wall Fixture? (Westinghouse 61242 Outdoor Wall Fixture Instruction Manual)

Answer

manuals.plus

Feb 14, 2025 - 08:56 PM


To install the Westinghouse 61242 Lighting Queensland One-Light Outdoor Wall Fixture, please follow these steps:

1. Turn off power at the circuit box to avoid electric shock.
2. Thread the mounting  xxxx  (A) into the mounting bar (B) and secure it with the small hex nut (C).
3. Place the mounting bar (B) flush against the wall at the desired mounting location. Use the side holes as a guide and mark where the pilot holes should be drilled. Ensure that the mounting bar is level for the fixture to hang straight.
4. Insert two plastic anchors (D) into the pilot holes (for drywall walls).
5. Align the outside mounting bar holes with the plastic anchors (D) and secure the mounting bar (B) in place using wood screws (E).
6. Make the electrical connection by loosening the terminal screws on the terminal block (M) and inserting the live, neutral, and ground terminals. Tighten the terminal screws and ensure there are no stray wires.
7. Place the back plate (H) over the mounting screws (A).
8. Secure the back plate into place with the washer (G) and cap nuts (I).
9. Remove the screws (F) from the fixture cover (L).
10. Install a lamp (not supplied) into the socket. Please do not exceed the maximum capacity recommended on the socket.
11. Secure the cage shade (J) using the screws (F) and washers (K).
12. Turn the power back on at the circuit box.

Please note that these instructions are a general guide, and it is essential to refer to the specific instructions provided in the Westinghouse 61242 Lighting Queensland One-Light Outdoor Wall Fixture Instruction Manual for accurate installation steps.