User Manual Q&AAnswer
Feb 14, 2025 - 04:48 AM
To replace the foot platforms on your Razor Power Core E90 Sprint scooter, you will need a 6 mm Allen wrench and a Phillips screwdriver. Here are the step-by-step instructions:
Step 1: Turn off the power switch and disconnect the charger from the scooter to ensure safety.
Step 2: Using the 6 mm Allen wrench, remove the four bolts located under the foot platform. There are two bolts on each side. Slide the platform bracket down.
Step 3: If you are only replacing the plastic platform, use a Phillips screwdriver to remove the four screws on top of the platform. There are two screws on each side. Lift the plastic platform off from the bracket.
Step 4: Reverse the steps to install the new foot platform. Slide the platform bracket back up and secure it with the four bolts using the 6 mm Allen wrench. If you replaced the plastic platform, align it with the bracket and secure it with the four screws using the Phillips screwdriver.
Step 5: Before using the scooter, make sure to charge the battery for 12 hours.
For further assistance, you can visit the Razor website at www.razor.com or call their toll-free number 866-467-2967. Their customer support is available Monday to Friday from 8:00 am to 5:00 pm Pacific Time.
Add New Comment