User Manual Q&AAnswer
Feb 14, 2025 - 04:32 AM
To wire the Applied Motion Products TXM24-S-Q Integrated StepSERVO Motor to a DC power source, follow these steps:
1. Make sure you have a 12-70V DC power supply.
2. Connect the positive terminal of the power supply to the "+" terminal on the drive.
3. Connect the negative terminal of the power supply to the "-" terminal on the drive.
4. If using an external fuse, connect it in series with the positive terminal of the power supply. It is recommended to use a 5 amp fast acting fuse.
5. Do not apply power until Step 3.
For more detailed information about power supply and fuse selection, please refer to the TXM24 Hardware Manual available at www.appliedmotion.com/support/manuals.
Add New Comment