User Manual Q&AAnswer
Feb 14, 2025 - 03:48 AM
To switch the color temperature on the KONSTSMIDE 7823 Otranto Lantern, follow these steps:
1. Ensure the lights are turned off.
2. Touch and hold the button for at least 4 seconds until the light turns on.
3. The color temperature will change when you touch the button.
4. To exit the color temperature mode, press the button again until the light goes off.
To adjust the dimmer on the lantern, follow these steps:
1. Ensure the lights are turned on.
2. Touch and hold the button for at least 1 second to activate the dimming function.
3. Continue holding the button to dim down the light.
4. Release the button when you reach the desired brightness level.
5. To brighten the light, touch and hold the button again.
Please note the following important information from the user manual:
- Do not put the battery in the fire as it may explode.
- Avoid exposing the lantern to fire or intense heat, as it may cause the battery to explode.
- It is recommended to charge the lantern for 30 minutes before using it. Use the provided USB cable and connect it to a DC 5V, Max lA adapter (adapter not included).
- The light source in this product is not replaceable. When it reaches its end of life, the entire product should be replaced.
If you have any further questions or concerns, please refer to the user manual or contact Konstsmide AB, the manufacturer, at the provided address.
Add New Comment