User Manual Q&AAnswer
Feb 14, 2025 - 03:33 AM
To install the Beper 40.490 Wall Mounted Hair Dryer, follow these steps:
1. Ensure that the appliance is off and unplugged from the wall socket.
2. Lay the wall base flat against the wall and use the holes as a guide to mark the desired position for installation.
3. Remove the wall base and start drilling where the marks on the wall have been traced. Use a drilling tip of 6 mm or ¼".
4. Insert the plastic anchors into the holes.
5. Lay the wall base flat on the wall, aligning the holes with the anchors, and insert the screws.
6. Tighten the screws clockwise until the wall base is firmly fixed and steady.
7. Insert the hair dryer into the wall base.
8. Plug the hair dryer into the wall socket.
Please note that it is strongly recommended to contact qualified personnel for installation to avoid any damages caused by incorrect mounting.
For more detailed instructions and illustrations, refer to the "Instructions for mounting" section in the Beper 40.490 Wall Mounted Hair Dryer Instruction Manual.
Add New Comment