User Manual Q&AAnswer
Feb 14, 2025 - 03:26 AM
The installation process for the AqualDEA B20W Transom Underwater LED Light is relatively straightforward. Here is a step-by-step guide based on the instruction manual:
1. Determine the mounting location: Choose a suitable location on the transom of your boat for installing the LED light. Ensure that the area is clean and free from any obstructions.
2. Drill mounting holes: Use a drill to create two mounting holes at the chosen location. The manual should provide specific measurements for the hole spacing.
3. Apply sealant: Apply a marine-grade sealant around the mounting holes to prevent any water from entering the boat through the holes.
4. Insert the light: Carefully insert the LED light into the mounting holes, ensuring that the wires are properly routed through the transom.
5. Connect the wires: Connect the positive (+) and negative (-) wires from the LED light to the corresponding terminals on your boat's electrical system. Follow the manual's wiring diagram for proper connections.
6. Secure the light: Use the provided screws to secure the LED light in place. Make sure it is tightly fastened to the transom.
7. Test the light: Turn on your boat's electrical system and test the LED light to ensure it is functioning properly.
It is important to note that these are general installation instructions, and it is always recommended to refer to the specific instructions provided in the AqualDEA B20W Transom Underwater LED Light instruction manual for the most accurate and detailed installation process.
Add New Comment