User Manual Q&AAnswer
Feb 14, 2025 - 03:02 AM
To reset the CyberPower P703URC1 surge protector after it switches off due to an overload, follow these steps:
1. Ensure that the overload condition is removed by disconnecting any devices that may have caused the overload.
2. Locate the ON/OFF Reset Control Switch on the surge protector. This switch also functions as a 15 Amp circuit breaker.
3. Switch the unit OFF by toggling the ON/OFF Reset Control Switch to the OFF position.
4. Wait for a few seconds to allow the surge protector to fully reset.
5. Switch the surge protector back ON by toggling the ON/OFF Reset Control Switch to the ON position.
6. The surge protector should now resume normal operation, providing power to all outlets.
Please note that it is important to identify and remove the cause of the overload before resetting the surge protector. If the overload condition persists or if you have any further issues, it is recommended to contact CyberPower technical support for assistance. You can reach them by visiting CyberPowerSystems.com/support or calling their toll-free number: 1-877-297-6937.
Add New Comment