How do I install the audison APBMW ReAMP 2 Plug and Play T Harness in my BMW with a 676 HiFi system? (audison APBMW ReAMP 2 Plug Play T Harness Owner's Manual)

Answer

manuals.plus

Feb 14, 2025 - 02:03 AM


To install the audison APBMW ReAMP 2 Plug and Play T Harness in your BMW with a 676 HiFi system, please follow the steps below:

1. Locate the RAM module in your BMW. It is usually located in the left rear corner of the trunk.

2. Connect the APBMW ReAMP 2 harness to the RAM module. The harness will bring out the front mid/high, rear mid/high, and under-seat low-pass signals.

3. Connect the speaker leads from the harness to your amplifier. The speaker leads are terminated with round male disconnects.

4. If you are using a Prima AP F8.9-bit processor, connect the input connector of the harness to the processor.

5. Retain the RAM module in the vehicle. It is necessary for the proper functioning of the system.

6. Note that the mono-center speaker used in the 676 HiFi system is deleted by default because it is mono and could affect stereo performance. A USS1 load device is built into the harness to simulate the presence of that speaker.

7. If you wish to install a center speaker, the speaker leads are present in the harness. The input signal wires can be modified and used, and the loading device should be removed.

8. It is important to confirm proper application. The APBMW ReAMP 1 and APBMW ReAMP 2 use identical connectors but with different pinouts, so they are not interchangeable.

Please refer to the audison APBMW ReAMP 2 Plug and Play T Harness Owner's Manual for more detailed instructions and diagrams.