User Manual Q&AAnswer
Feb 14, 2025 - 12:15 AM
To install the WATERWARE FWK03SN Sink Mixer, follow these steps:
1. Cut a 35mm hole in diameter and ensure there is a 60mm circle space for mounting.
2. Underneath the mounting hole, xxxx down the lock nut until the end of the Mixer tail. Feed the metal washer, then the rubber washer from the upside onto the Mixer Tail.
3. Feed the hoses through the mixer tail and then both the mixer tail and hoses through the hole.
4. Position the O-ring in the dress ring groove and xxxx the hoses into the mixer body as shown.
5. xxxx the mixer tail into the mixer body and place the mixer into position.
6. Underneath the mounting hole, firmly fasten the locknut and then tighten the screws.
7. Connect the hoses to the water supply.
8. Test and check for leaks.
9. Finished work.
Please refer to the WATERWARE FWK03SN Sink Mixer Installation Guide for visual illustrations and further details.
Note: It is important to ensure that the installation complies with Australia standard AS/NZS3500 or relevant local authority requirements.
Source: WATERWARE FWK03SN Sink Mixer Installation Guide
Add New Comment