User Manual Q&AAnswer
Feb 14, 2025 - 12:14 AM
To install the Right Weigh 201-EBT-20B-TT Bluetooth Enabled Exterior Digital Load, follow these steps:
1. Ensure that you have all the necessary components included in the package: 1 x 201-217-30 gauge and mounting bracket, 1 x 221-SK epoxy strain sensor installation kit, and 1 x 218-SK weld strain sensor installation kit.
2. Set the sensor configuration on the gauge to detect 2 Spring Sensors. You can find detailed instructions on how to set the sensor configuration in the Spring Suspension Gauge manual.
3. Determine the appropriate sensor locations based on your application. For a tractor or straight truck with Mack Camelback Suspension, mount the gauge anywhere on the outside of the vehicle.
4. Install strain sensor "A" on the top, center of the steer axle using the 221-SK installation kit. Refer to the 221-SK manual for detailed instructions on how to install the strain sensor.
5. Install strain sensor "B" on the top, center of the trunnion tube that runs between the two drive axles using the 218-SK installation kit. Consult the 218-SK manual for step-by-step instructions on how to install the strain sensor.
6. Set the gauge to Independent (IDP) mode to view separate weights for the steer axle and the drive axle group. You can find information on how to set the mode in the Spring Suspension Gauge manual.
For more detailed instructions and information, please refer to the manuals provided with the Right Weigh 201-EBT-20B-TT Bluetooth Enabled Exterior Digital Load.
Add New Comment