How do I replace the float in the GARNET 808-P2 SeeLevel Display Truck Level Gauge? (GARNET 808-P2 SeeLeveL Level Gauge Instruction Guide)

Answer

manuals.plus

Feb 13, 2025 - 11:42 PM

To replace the float in the GARNET 808-P2 SeeLevel Display Truck Level Gauge, follow these steps:

1. Remove the head cap and disconnect the optical fiber from its connector.
2. Disconnect the nut on the brass fitting and remove the fiber from the head.
3. Mark the tube at the point that it exits the 1” compression fitting.
4. Loosen the top of the 1” compression fitting.
5. Remove the bottom portion of the 1” compression fitting from the coupler in the tank.
6. Carefully lift the tube out of the tank. The float will remain sitting on the support.
7. Retrieve and replace the float. Note that the cone shape should face up.
8. Reinstall the tube, ensuring that the end goes through the hole in the float and into the support.
9. Tighten the bottom portion of the 1” compression fitting.
10. Using the mark made in step 3, position the tube so that it is in the same location as before.
11. Tighten the top of the 1” compression fitting.
12. Replace the fiber into the head and tighten the brass nut.

If you are a Canadian customer, pack up the old float and ship it back prepaid to Garnet Instruments via Loomis, Tiger, or Greyhound. If you are a US customer, pack up the old float and ship it back prepaid to Garnet Instruments via UPS or FedEx. Note that if the float was sunk and is full of fluid, do not ship it back. Discard it following local disposal guidelines.

It is important to note that if the parts were provided under warranty, you must ship the old parts within 7 days or you will be invoiced. Garnet staff will inspect and check out all returned parts. If tampering or improper original installation is found, Garnet Instruments reserves the right to invoice partially or fully for the new parts. All new parts are guaranteed for three (3) months or for the remaining length of the original warranty, whichever is longer.

For technical support, you can call 1-800-617-7384. For more information, you can contact Garnet Instruments via email at info@garnetinstruments.com (Canada) or infous@garnetinstruments.com (USA).