User Manual Q&AAnswer
Feb 13, 2025 - 11:41 PM
To install and start using the multiLane ML1105 Automated DAC Testing Software, follow these steps:
1. Open the ML1105 setup file that you have downloaded.
2. Run the ML1105 installer and follow the on-screen instructions to complete the installation.
3. Connect the multiLane ML4035 instrument to the local network using an RJ45/LAN cable.
4. Launch the ML1105 GUI (Graphical User Interface) software.
5. Choose the model of the instrument to be used (ML_4035_TDR/ML_4025).
6. Connect to the instrument by entering the IP address of the target instrument(s). The IP address can be found on the back side of the instrument.
7. The previously connected IP addresses will appear in the drop-down list next to the type box.
8. If there is a connection failure, a pop-up message will appear indicating a connection error.
9. Once the connection is established, the ML1105 GUI will be initialized and all the features will be ready for use.
You can now start using the ML1105 Automated DAC Testing Software for evaluating and testing your cables.
Add New Comment