User Manual Q&AAnswer
Feb 13, 2025 - 11:17 PM
To correctly attach and align the SHAD K0ZH11ST Rear Case Mounting Black, please follow the steps below:
1. Gather the necessary tools: You will need a screwdriver or wrench, depending on the type of screws provided with the kit.
2. Ensure the motorcycle's rear rack or mounting base is clean and free from any debris or obstructions.
3. Place the SHAD K0ZH11ST Rear Case Mounting Black onto the rear rack or mounting base, aligning the holes on the mounting plate with the corresponding holes on the rack.
4. Insert the screws provided through the holes on the mounting plate and into the rack or mounting base. Do not fully tighten the screws at this stage.
5. Once all the screws are inserted, ensure that the SHAD K0ZH11ST Rear Case Mounting Black is correctly aligned and centered on the motorcycle. Adjust the position if necessary.
6. Starting from one corner, tighten each xxxx gradually, alternating between screws to ensure even pressure distribution. Use the appropriate tool to tighten the screws securely.
7. After all the screws are tightened, double-check the alignment and stability of the SHAD K0ZH11ST Rear Case Mounting Black. Make sure it is securely attached to the motorcycle and does not move or wobble.
8. If everything is properly aligned and attached, you can now proceed to install the rear case onto the mounting plate according to the instructions provided with the rear case.
Remember, do not fully tighten the screws until you have ensured that the SHAD K0ZH11ST Rear Case Mounting Black is correctly attached and aligned. This allows for adjustments and ensures a proper fit.
Add New Comment