User Manual Q&AAnswer
Feb 13, 2025 - 10:56 PM
To set the full-scale level on the GARNET T-DP0301-B Data Portal and Remote Display, follow these steps:
1. Determine the maximum volume that can be displayed and pick a full-scale amount that is equal to or greater than this volume.
2. Press both the NEXT MENU and UP/ENTER buttons on the back panel of the display. The display will show "ACAL". Release both buttons.
3. The display will show the existing calibration with the left digit bright. Press the UP/ENTER button to change the bright digit. Press the NEXT MENU button to go to the next digit.
4. Set all 4 digits, then press NEXT MENU again to set the decimal point. The decimal point will be bright to indicate that it is selected. Press the UP/ENTER button to select either x.xxx, xx.xx, xxx.x, or no decimal. For the best accuracy of the analog output, try to use all digits such as 500.0 instead of just 500.
5. After setting the decimal, press NEXT MENU again. The display will show "Stor". Press UP/ENTER to store the calibration and exit the setting menu. The display will continue to show "Stor" for a moment and then will show "do" for a second. Normal operation will resume.
6. If you do not want to store the calibration, press NEXT MENU again and the display will show "About". Press UP/ENTER to abort, which exits the calibration menu without saving.
7. If you press NEXT MENU again from the "Abrt" display, the menu will return to the beginning with the left digit selected by being bright.
8. If the full-scale calibration is below 103, the display will be unable to calculate a valid calibration and will show "color" (calibration error) after a few seconds. The existing calibration will be retained, and the display will return to normal operation.
Please refer to the GARNET T-DP0301-B Data Portal and Remote Display User Manual for more detailed instructions and illustrations.
Add New Comment