How do I pair my Breezeline Stream TV Remote with my Stream TV box? (breezeline Stream TV Remote Essentials User Guide)

Answer

manuals.plus

Feb 13, 2025 - 09:49 PM

To pair your Breezeline Stream TV Remote with your Stream TV box, follow these steps:

1. Make sure your Stream TV box is turned on and within range of the remote.
2. Press the TiVo button on the remote to start the pairing process.
3. The indicator light on the remote will blink amber/yellow slowly while it searches for the Stream TV box.
4. Once the remote finds the Stream TV box, the indicator light will blink amber/yellow quickly 5 times to indicate successful pairing.

If for any reason your remote becomes unpaired, you can re-pair it by following these steps:

1. Press and hold the TiVo and Back buttons simultaneously until the indicator light turns red.
2. The indicator light will blink amber/yellow slowly while it searches for the Stream TV box.
3. Once the remote finds the Stream TV box, the indicator light will blink amber/yellow quickly 5 times to indicate successful pairing.
4. If a list of remotes appears on the screen, use the directional pad to highlight the remote and press OK/SELECT to choose the remote and pair it.

If you need to reset and re-pair your remote, follow these steps:

1. Press and hold the TiVo and Power buttons on the remote simultaneously for approximately 3 seconds, until the activity light turns solid red.
2. Press the Volume Down button three times.
3. Press the TiVo button.
4. The activity light will flash red three times.
5. Remove the batteries from the remote for at least 10 seconds. This will reset the remote.
6. Insert the batteries back into the remote.
7. Press the TiVo button to start the pairing process.
8. The indicator light will blink amber/yellow slowly while it searches for the Stream TV box.
9. Once the remote finds the Stream TV box, the indicator light will blink amber/yellow quickly 5 times to indicate successful pairing.

Remember, if you experience any issues or odd behavior after programming the remote, you can go to Menu > Settings > Remote Settings > Remote Control Programming and try a different code.