User Manual Q&AAnswer
Feb 13, 2025 - 08:55 PM
To install the batteries for the ROBO Shark and remote control, please follow these steps:
1. For the ROBO Shark:
a. Using a Phillips screwdriver, open the compartment lid (A) located under Roboshark's mouth.
b. Using a Phillips screwdriver, open the waterproof battery compartment (B).
c. Insert 3 AAA batteries (not included) into the compartment, following the polarity symbols (+) as indicated.
d. Close the waterproof cover and tighten the screws to prevent water from entering.
2. For the remote control:
a. Using a Phillips screwdriver, open the battery compartment (C) located behind the remote control.
b. Insert 3 AAA batteries (not included) into the compartment.
c. Close the compartment securely.
Please note that it is important to ensure the batteries are inserted correctly, following the polarity symbols. Additionally, make sure to tighten the screws and close the compartments properly to prevent water from entering.
For more detailed instructions and illustrations, please refer to the Jupiter Creations 17006 ROBO Shark Instruction Manual provided with the product.
Remember, the ROBO Shark's motor will only run when the shark is in the water, and the remote control needs to be turned on and paired with the shark for operation.
Add New Comment