User Manual Q&AAnswer
Feb 13, 2025 - 08:45 PM
To pair the MARMITEK BoomBoom 100 with your Bluetooth headphones, please follow these steps:
1. Ensure that the BoomBoom 100 is set to transmitter (TX) mode by sliding the TX/Off/RX switch to the TX position. The blue LED will start blinking slowly.
2. Connect the BoomBoom 100 to your TV or computer using the appropriate cable (C, D, or E).
3. Put your Bluetooth headphones into pairing mode. Refer to your headphone's user manual for instructions on how to do this.
4. Slide the multifunctional switch (2) on the BoomBoom 100 all the way to the right (BT). The LED will start blinking red/blue, indicating that the BoomBoom 100 is ready for pairing.
5. Slide the multifunctional switch back to the center position for optical connection (OPT) or all the way to the left for analog connection (AUX).
6. Both the BoomBoom 100 and your headphones should be in pairing mode. The BoomBoom 100 will remain in pairing mode for up to 30 seconds until the connection is established. Once the connection is established, the LED will turn blue or green.
7. The sound from your TV will now be played over your Bluetooth headphones.
Note: The BoomBoom 100 can remember up to 8 paired smartphones or Bluetooth devices. If you want to pair a second Bluetooth device, follow the same steps and put the second device in pairing mode after pairing the first device. The pairing process may take up to two minutes.
Please refer to the user manual for more detailed instructions and troubleshooting tips.
Add New Comment