How do I install the Westinghouse 61224 Niko Outdoor Wall Fixture? (Westinghouse 61224 Niko Outdoor Wall Fixture Instruction Manual)

Answer

manuals.plus

Feb 12, 2025 - 05:14 AM


To install the Westinghouse 61224 Niko Outdoor Wall Fixture, please follow these steps:

1. Turn off power at the circuit box to avoid electric shock.
2. Thread the mounting  xxxx  (A) into the mounting bar (B) and secure it with the small hex nut (C).
3. Place the mounting bar (B) flush against the wall at the desired mounting location. Use the side holes as a guide and mark where pilot holes are to be drilled.
4. Inset two plastic anchors (D) into the pilot holes (for drywall walls).
5. Align the outside mounting bar holes with the plastic anchors (D) and secure the mounting bar (B) into place using wood screws (E).
6. Make an electrical connection by loosening the terminal screws on the terminal block (M) and inserting the live, neutral, and ground terminals. Tighten the terminal screws and ensure there are no stray wires.
7. Place the back plate (H) over the mounting screws (A).
8. Secure the back plate (H) into place with the washer (G) and cap nuts (I).
9. Install the lamp (not supplied) into the fixture. Please do not exceed the maximum capacity recommended on the socket.
10. Secure the bottom cover (J) using the screws (F).
11. Turn the power back on at the circuit box.

Please note that these instructions are a general guide. For specific details and illustrations, refer to the instruction manual provided with the Westinghouse 61224 Niko Outdoor Wall Fixture. If you are unsure or have any questions, it is recommended to contact a qualified electrician for assistance.