User Manual Q&AAnswer
Feb 12, 2025 - 01:10 AM
To connect the CP2112 evaluation board to your PC, follow these steps:
1. Connect one end of the USB cable to a USB port on your PC.
2. Connect the other end of the USB cable to the USB connector on the CP2112 evaluation board.
3. Connect the SDA, SCL, and Ground pins on the CP2112 to an SMBus device. If you are using the pull-up resistors on the CP2112 evaluation board, external pull-up resistors are not needed.
For more detailed information, refer to the "CP2112 Hardware Interface" section in the CP2112-EK Evaluation Kit User Guide.
Add New Comment