How do I connect and set up the LEDMY LC243-MICIR-A1 Single Button Strip Light with Controller? (LEDMY LC243-MICIR-A1 Strip Light Controller User Manual)

Answer

manuals.plus

Feb 12, 2025 - 12:13 AM


To connect and set up the LEDMY LC243-MICIR-A1 Single Button Strip Light with Controller, follow these steps:

1. Power on the device by connecting the 12V DC power supply to the control box.
2. Long press the button on the control box for 5 seconds to enter the distribution network pattern. The indicator light will flash for EZ mode.
3. If you want to enter the hot network configuration mode, continue holding down the button for another 5 seconds while the indicator light is in the fast blinking state.
4. Complete the network configuration within 3 minutes by following the operation steps on the mobile app.
5. Alternatively, you can enter the network distribution mode by turning the device on or off for three times, which will put the indicator light into the flash state.
6. If you want to enter the AP Slow flash network configuration mode, long press the button for 5 seconds after the device is powered on until the indicator light starts blinking. Then, long press the button for another 5 seconds until the indicator light turns into the blinking state. Follow the operation steps on the mobile app for network distribution.
7. The device can also enter the AP Slow flash network configuration mode by switching on and off for three times into the fast blinking state, and then switching on and off for three times into the slow blinking state.

Please refer to the user manual for more detailed instructions and troubleshooting information.