User Manual Q&AAnswers
Feb 11, 2025 - 11:50 PM
To install the Princess 348035 Smart Infrared Panel Heater 350, you have two options: wall mounting or using the supplied feet for floor placement. Here are the installation steps:
Wall Mounting:
1. Ensure that the product is installed at least 15 cm from the floor and 50 cm from the ceiling.
2. Mount the heater at 4 points on the wall, ensuring there is a 300 mm clearance on all sides of the heater.
3. Measure the distance between the center of each bracket both horizontally and vertically to ensure drilling holes in the correct place. Mark the positions of the 4 holes to be drilled on the wall.
4. Drill the holes in the wall and insert the supplied plastic expanded plugs. xxxx the 4 supplied screws into the plastic expanded plugs.
5. Attach the panel heater onto the screws and move the heater to the left so that the screws drop into the securing slots.
Foot Assembly:
1. If you choose not to mount the heater on the wall, you can use the supplied feet.
2. Remove the bottom screws from the heater housing.
3. Place the feet and secure them by putting the screws back into the housing.
4. Ensure that the feet are located correctly on the bottom end of the heater.
Please refer to the instruction manual for detailed diagrams and instructions on installation.
Feb 11, 2025 - 11:51 PM
To install the Princess 348035 Smart Infrared Panel Heater 350, you have two options: wall mounting or using the supplied feet for floor placement. Here are the installation steps:
Wall Mounting:
1. Ensure that the product is installed at least 15 cm from the floor and 50 cm from the ceiling.
2. Mount the heater at 4 points on the wall, ensuring there is a 300 mm clearance on all sides of the heater.
3. Measure the distance between the center of each bracket both horizontally and vertically to ensure drilling holes in the correct place. Mark the positions of the 4 holes to be drilled on the wall.
4. Drill the holes in the wall and insert the supplied plastic expanded plugs. xxxx the 4 supplied screws into the plastic expanded plugs.
5. Attach the panel heater onto the screws and move the heater to the left so that the screws drop into the securing slots.
Foot Assembly:
1. If you choose not to mount the heater on the wall, you can use the supplied feet.
2. Remove the bottom screws from the heater housing.
3. Place the feet and secure them by putting the screws back into the housing.
4. Ensure that the feet are located correctly on the bottom end of the heater.
Please refer to the instruction manual for detailed diagrams and instructions on installation.
Add New Comment