User Manual Q&AAnswer
Feb 11, 2025 - 11:43 PM
To connect your headphones to the PreSonus HP2 Personal Headphone Amplifier, follow these steps:
1. Locate the 1/8" stereo headphone output on the front panel of the HP2. This is where you will plug in your headphones.
2. Insert the headphone plug into the 1/8" stereo headphone output. The tip of the plug should go into the left signal, the ring into the right signal, and the sleeve into the ground.
3. Adjust the volume control on the front panel to set the desired level of the headphone output.
4. If you are using a stereo source, make sure the mode switch on the front panel is set to Stereo Mode. This will send the left input to the left headphone and the right input to the right headphone.
5. If you are using a mono source, connect it to either the left or right input on the rear panel. Engage the mono switch on the front panel and turn the pan control all the way to the corresponding side (e.g., if your source is connected to the left input, turn the pan control all the way to the left side). This will send the signal equally to both headphone channels.
Please refer to the user manual for more detailed instructions and information on the PreSonus HP2 Personal Headphone Amplifier.
Add New Comment